Kurzweil SPS4-8 Fiche technique télécharger pdf (Page 65)

Setup Mode

Saving in Setup Mode

7-11

Saving in Setup Mode

When you make a change to the current Setup using the Control Knob, the Save button

LED will light up indicating that a change has been made to the Setup. To save the current

Setup, press the Save button once. The Save button LED will blink to indicate that a save

operation is underway, and the User Bank LED will also be lit. If the Setup is an edited

Factory Setup (i.e., a Setup in Bank 1), the default save location will be the next available

location in the User Bank. If all 64 User Bank slots are taken, then the Setup is saved in the

last slot in the User Bank, overwriting what was previously in that slot. If the current Setup

is a Setup already in the User Bank, then the Setup is saved in its current Setup slot. At this

point, you can rename the new Setup using the secondary alphanumeric functions of the

Group Select and Sound Select buttons.

When the Save button LED is blinking (which means that you pressed Save, and a save

operation is underway), pressing Save again will cause the system to save the current Setup

to the indicated Group and Sound in the User Bank. If you want to save it to a different

location in the User Bank, select the location via the Group Select and Sound Select buttons

(or using the Value buttons) before pressing Save again.

Pressing any other button while the Save button is blinking will cancel the save operation.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 119 120

Pas de commentaire

Kurzweil SPS4-8 Fiche technique Page 65