Kurzweil SP4-7 Instructions d'exploitation Page 107
- Page / 118
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Troubleshooting
CommonProblems
12-3
Audio Problems
CAUTION: DO NOT TROUBLE SHOOT AUDIO PROBLEMS USING
HEADPHONES. ADDITIONALLY, ALWAYS BE AWARE OF THE VOLUME
LEVELS ON THE SP4 AND ON THE CONNECTED AUDIO SYSTEM OR MIXER.
NOTE: When diagnosing audio problems, set the SP4 to play its demo sequence rather then
intermittently pressing keys. This will prevent any unexpectedly loud volume changes.
If there is no sound from your SP4, check if one of the following might be the issue:
The volume slider is turned
down.
Slowly push the volume slider up.
The volume control on the
audio system or mixer is turned
down.
Slowly turn the volume control up.
The signal source selection on
the audio system or mixer is
incorrect.
Set the volume of the audio or mixer
to the lowest level, select the correct
signal source, and then slowly turn up
the volume.
The audio cables are not
securely plugged into the SP4,
audio system, or mixer.
Set the volume of the audio or mixer
to the lowest level, securely plus in
the audio cables on both ends, and
then slowly turn up the volume.
The audio cable is of an
incorrect type.
Obtain and securely connect an
audio cable of the correct type. The
SP4 accepts both balanced (TS) and
unbalanced (TRS) 1/4-inch audio
cables.
If you can hear sound but it is low or distorted, check if one of the following might be the
issue:
The audio cables are not
securely plugged into the SP4,
audio system, or mixer.
Set the volume of the audio system
or mixer to the lowest level, securely
plus in the audio cables on both ends,
and then slowly turn up the volume.
- Musician’s Guide 1
- Important Safety Instructions 3
- Table of Contents 5
- Chapter 11 9
- Chapter 12 10
- Appendix A 10
- Appendix B 10
- Chapter 1 11
- Introduction 11
- Pedals (Optional) 12
- Staying Current 12
- Do You Have Everything? 12
- Chapter 2 13
- Getting Started 13
- Use Your SP4 14
- Start Up Details: 14
- The Rear Panel 14
- The MIDI (IN and OUT) Ports 14
- The Pedal Jacks 14
- The USB Port 15
- The DC Power Jack 15
- The HEADPHONES Jack 15
- Left Speaker 16
- Right Speaker 16
- Headphones 16
- Connecting Pedals 17
- Connecting a Switch Pedal 18
- Connecting a Control Pedal 18
- MIDI Contr oller 20
- Chapter 3 21
- Features of the SP4 21
- Pitch and Mod Wheels 22
- Function Buttons 22
- Program Button 23
- Setup Button 23
- Edit Setup Button 23
- Global Button 23
- Save Button 23
- Split (Zone 1) Button 24
- Layer (Zone 2) Button 24
- Shift Button 24
- The Control Knob 25
- Display and Value Buttons 26
- Chan / Param Buttons 26
- Object Select Buttons 27
- Bank Select Button 28
- Group Select Buttons 28
- Sound Select Buttons 28
- Alphanumeric Data Entry 29
- Double Button Presses 29
- Jump Value 30
- Jump Parameter 30
- MIDI Program Change 30
- DoubleButtonPresses 32
- Chapter 4 33
- Terminology 33
- Chapter 5 35
- The Operating Modes 35
- Setup Mode 36
- Edit Setup Mode 36
- Global Mode 37
- System Mode 37
- Functions 38
- The Split Function 38
- The Layer Function 38
- MIDI Program Change Function 39
- Demo Function 40
- Chapter 6 41
- Program Mode 41
- Table of Programs 42
- Selection 43
- Group Sound 44
- Transposition 46
- Saving in Program Mode 50
- SavinginProgramMode 52
- Chapter 7 53
- Table of Setups 54
- About Zones 57
- Muting Zones 58
- Saving in Setup Mode 63
- SavinginSetupMode 64
- Chapter 8 65
- The Parameters of a Setup 66
- The Zone-specic Parameters 68
- Local Program 68
- Destination 68
- MIDI Bank 69
- MIDI Program 70
- Bank Mode 71
- Zone Status 71
- Entry Program Change 71
- Aux Send Level 72
- Transpose 72
- Entry Pan 72
- Entry Volume 72
- Low Velocity 72
- High Velocity 73
- High Key 73
- Bend Range Down 73
- Bend Range Up 73
- TheZone-specicParameters 75
- The Foot Switch Parameters 77
- About Auxiliary Effects 78
- Common Parameters 78
- Aux Effect Override 78
- Aux Effect Channel 79
- Chapter 9 81
- The Global Parameters 83
- Velocity Map (VMap) 83
- FX Select (FXSel) 84
- Channel Enable (ChanEn) 84
- Destination (Dest) 84
- Bank Select (BankSel) 85
- Program Change (ProgChg) 85
- Sysex ID 86
- The “Hard Reset?” Dialogue 87
- The “Save All?” Dialogue 87
- The “Load All?” Dialogue 88
- Chapter 10 89
- Buttons in System Mode 90
- Update Software 90
- Run Diagnostics 91
- System Reset 91
- File Utilities 92
- Tutorials 93
- C4C3B2E1 G7 95
- 76 Real Vibes 96
- 88 Solo Flute 97
- Module 1 99
- Module 2 99
- Module 3 99
- Module 4 99
- Zone1 C6-G7 Module1 1 2 3 100
- Zone2 F4-B5 Module2 2 5 112 100
- Zone3 C3-E4 Module3 3 3 67 100
- Zone4 E1-B2 Module4 4 0 23 100
- Connecting MIDI 103
- Managing Object Data 103
- Updating Software 103
- Other Tutorials 103
- Restoring Factory Defaults 104
- Troubleshooting 105
- Audio Problems 107
- MIDI Problems 108
- Pedal Problems 109
- Switch Pedal Problems 109
- Control Pedal Problems 110
- If None of the Above 110
- Service Centers 111
- Diagnostics 111
- IfNoneoftheAbove 112
- MIDI Implementation 113
- Physical Specications 115
Produits connexes et manuels pour Claviers MIDI Kurzweil SP4-7
Claviers MIDI Kurzweil PC3LE8 Spécifications
(379 pages)
(379 pages)
© 2020, manymanuals.fr. Tous droits réservés | 0.331 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels