Kurzweil SP4-7 Instructions d'exploitation télécharger pdf (Page 85)

Global Mode

TheGlobalParameters

9-5

Local MIDI data is sent only to the SP4 sound engine. The

MIDI OUT port is disabled.

MIDI MIDI data is sent only through the MIDI OUT port.

The sounds of the SP4 are disabled.

Local+MIDI MIDI data is sent both to the SP4 sound engine and

through the MIDI OUT port.

Select the desired destination depending on your needs. If you want to play the SP4, but

not send any MIDI information to other MIDI instruments, then select Local. If you want

to use the SP4 strictly as a MIDI controller for the other modules in your MIDI chain,

then select MIDI. If you want to make use of the SP4’s sounds as well as use it as a MIDI

controller, then select Local+MIDI.

Pressing both Value buttons simultaneously will set this parameter to Local+MIDI.

Bank Select (BankSel)

The Bank Mode parameter determines the controller number with which MIDI Bank

change messages are transmitted. For MIDI Bank change messages, various manufacturers

have chosen different MIDI controller numbers. Most have chosen 0, 32, or both.

You can set this parameter to any of the following four controller IDs:

None MIDI Bank change messages are disabled.

Ctl0 MIDI Bank change messages are sent with controller

number 0.

Ctl32 MIDI Bank change messages are sent with controller

number 32.

Ctl0/32 MIDI Bank change messages are sent with both

controller numbers 0 and 32.

Pressing both Value buttons simultaneously will set this parameter to Ctl0/32.

Program Change (ProgChg)

The Program Change (ProgChg) parameter determines whether or not entry MIDI Program

Change messages are sent for Setups. You can set this parameter to either On or Off.

Pressing both Value buttons simultaneously will set this parameter to On.

Note that when you perform a MIDI Program Change through MIDI Program Change

Mode, the setting of the Global Program Change parameter (as well as the setting of the

Global MIDI Transmit parameter) is ignored.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 117 118

Pas de commentaire

Kurzweil SP4-7 Instructions d'exploitation Page 85