Kurzweil SP4-7 Instructions d'exploitation télécharger pdf (Page 50)

Program Mode

ChangingtheTransmitMIDIChannel

6-10

Layer Transposition

This parameter determines the transposition of the Secondary Voice relative to that of

the Primary Voice—it can be set to -24, -12, 0, 12, and 24. By default, Layer Transposition

is set to 0. Note that if the Primary Voice is transposed, then the Secondary Voice will be

transposed by the same amount in addition to being transposed by the amount set for the

Layer Transposition.

Changing the Transmit MIDI Channel

Pressing the Chan / Param Up (

) or Down (

) button will change the MIDI transmit

channel, incrementing or decrementing it respectively. Pressing both Chan / Param Up (

)

and Down (

) at the same time will reset the current MIDI channel to 1.

The MIDI channel will be shown briey in the display before the display changes back to

showing the current Program on the selected MIDI transmit channel.

Saving in Program Mode

When you make a change to the current Program using the Control Knob, the Save button

LED will light up indicating that a change has been made to the Program. To save the

current Program, press the Save button once. The Save button LED will blink to indicate

that a save operation is underway, and the User Bank LED will also be lit. If the program is

an edited Factory Program (i.e., a Program in Bank 1 or Bank 2), the default save location

will be the next available location in the User Bank. If all 64 User Bank slots are taken, then

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 117 118

Pas de commentaire

Kurzweil SP4-7 Instructions d'exploitation Page 50