Kurzweil SP4-7 Instructions d'exploitation télécharger pdf (Page 76)

Edit Setup Mode

TheZone-specicParameters

8-12

Controller

Number

Destination

Name

Description

135 KeyVel KeyVelocity

136 ProgInc ProgramIncrement—incrementscurrentprogramnumber.

137 ProgDec ProgramDecrement—decrementscurrentprogramnumber.

138 ProgGoto GotoProgram—selectsprogram.

139 SetupInc SetupIncrement—incrementscurrentsetupnumber.

140 SetupDec SetupDecrement—incrementscurrentsetupnumber.

141 SetpGoto GotoSetup—selectssetup.

142–144 MIDI142–144 MIDIControllers142–144

145 TransUp TransposeUp(ST)

146 TransDown TransposeDown(ST)

147–148 MIDI147–148 MIDIControllers147–148

149 MuteZn MuteZone–valuesabove64willmutethezone,values

beloworequalto64willunmutethezone.

150–160 MIDI150–160 MIDIControllers150–160

161 Panic Panic

162 SoloZn SoloZone

163–178 MIDI163–178 MIDIControllers163–178

Entry Value

The Entry Value parameter determines the value of the continuous controller that is sent

as a MIDI message when the current Setup is loaded. You can set this parameter to any

number between 0 and 127, or to None. Pressing both Value buttons simultaneously will set

this parameter to None.

If Entry Value is set to None, then when you load the current Setup, the controller will be

at whatever value corresponds to its current position. If you specify an Entry Value, then a

MIDI controller message with this value will be sent when you load the current Setup.

Exit Value

The Exit Value parameter determines the value of the continuous controller that is sent as a

MIDI message when the current Setup is exited. You can set this parameter to any number

between 0 and 127, or to None. Pressing both Value buttons simultaneously will set this

parameter to None.

If Exit Value is set to None, then when you leave the current Setup, the controller will be

at whatever value corresponds to its current position. If you specify an Exit Value, then a

MIDI controller message with this value will be sent when you close the current Setup.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 117 118

Pas de commentaire

Kurzweil SP4-7 Instructions d'exploitation Page 76